Honda CR-V: To Play a Disc

To load or play discs, the ignition switch must be in the ACCESSORY (I) or ON (II) position.

You operate the disc changer with the same controls used for the radio.

To select the disc changer, press the CD button (CD/AUX button on models with satellite radio), the disc and track numbers are displayed.

The system will continuously play a disc until you change modes.

Do not use discs with adhesive labels.

Do not use discs with adhesive labels.

The label can curl up and cause the disc to jam in the unit.

This audio system can also play CD-Rs and CD-RWs compressed in MP3 or WMA formats. The numbers of the folder and track playing are shown in the display on the disc player. A disc can support up to 255 folders, and each folder can hold up to 255 playable files. A disc can hold up to 999 files in total.

When there are more than 99 folders in a disc, the audio display only shows two digits.

NOTE:

If a file on an MP3 or WMA disc is protected by digital rights management (DRM), the audio unit displays UNSUPPORTED, and then skips to the next file.

Video CDs and DVDs do not work in this unit.

The specifications for compatible MP3 files are:
Sampling frequency:
32/44.1/48 kHz (MPEG1)
16/22.05/24 kHz (MPEG2)
Bitrate:
32/40/48/56/64/80/96/112/128/160/192/224/256/320 kbps (MPEG1)
8/16/24/32/40/48/56/64/80/96/112/128/160 kbps (MPEG2)
Compatible with variable bitrate and multi-session
Supported standards:
MPEG1 Audio Layer3
MPEG2 Audio Layer3
Number of layers (including ROOT): Over 8 layers

The specifications for compatible WMA files are:
Sampling frequency:
32/44.1/48 kHz
Bitrate:
48/64/80/96/128/160/192 kbps
Compatible with variable bitrate and multi-session
Supported standards:
WMA version 7/8/9
Number of layers (including ROOT): Over 8 layers

READ NEXT:

 Loading Discs in the In-dash Disc Changer

Your vehicle’s in-dash disc changer holds up to six discs. 1. Press the LOAD button until you hear a beep and see ‘‘LOAD’’ on the display. To load only one CD, press and release th

 Text Data Display Function

Each time you press the TITLE button, the display shows you the text, if the disc was recorded with text data. You can see the album, artist, and track name in the display. If a disc is rec

 To Change or Select Tracks/Files

You can use the SEEK button while a disc is playing to change tracks (files in MP3/WMA mode). In MP3/WMA mode, use the or button to select folders in the disc, and use the SEEK button to

SEE MORE:

 A FewWordsAbout Safety

Your safety, and the safety of others, is very important. And operating this vehicle safely is an important responsibility. To help you make informed decisions about safety, we have provided operating procedures and other information on labels and in this manual. This information aler

 System Diagnostic Mode

Start-up procedure and Diagnosis Menu 1. Turn the ignition switch to the ON (II) position. Press and hold the Menu, the Map/Guide, and the Cancel buttons. Keep them pressed for approximately 3 seconds. The display screen then goes directly to the Diagnostic Menu. DIAGNOSTIC MENU SCREEN 2. After th

© 2016-2024 Copyright www.hcrv.net