Jeep Liberty: To Activate
Push the ON/OFF button. The Cruise Indicator Light in the instrument cluster will illuminate. To turn the system off, push the ON/OFF button a second time. The Cruise Indicator Light will turn off. The system should be turned off when not in use.
WARNING!
Leaving the Electronic Speed Control system on
when not in use is dangerous. You could accidentally
set the system or cause it to go faster than you want.
You could lose control and have an accident. Always leave the system OFF when you are not using it.
Electronic Speed Control — If Equipped
When engaged, the Electronic Speed Control takes over
accelerator operations at speeds greater than 25 mph
(40 km/h).
The Electronic Speed Control buttons are located on the
right side of the s ...
To Set A Desired Speed
Turn the Electronic Speed Control ON. When the vehicle
has reached the desired speed, press the SET (-) button
and release. Release the accelerator and the vehicle will
operate at the selected s ...
See also:
Changing the climate control air filter
(For Evaporator and Blower Unit)
(If Installed)
The climate control air filter is located in front of
the evaporator unit behind the glove box.
It helps to decrease the amount of pollutants
e ...
How can I prepare for my next OBD II emission inspection?
• If your Check Engine (MIL) light is lit – or
was lit but went out without service, have
your vehicle diagnosed and, if necessary,
serviced by a qualified Volvo technician.
• If you rece ...
Transfer Case
Refer to the Maintenance Schedule to determine how often to check the lubricant
and when to change it. See Maintenance Schedule on page 11‑3. ...