Hyundai Tucson: Tire maintenance - Consumer information, reporting safety defects & binding arbitration of 
warranty claims - Hyundai Tucson Owner's ManualHyundai Tucson: Tire maintenance

In addition to proper inflation, correct wheel alignment helps to decrease tire wear. If you find a tire is worn unevenly, have your dealer check the wheel alignment.

When you have new tires installed, make sure they are balanced. This will increase vehicle ride comfort and tire life. Additionally, a tire shoud always be rebalanced if it is removed from the wheel.

WARNING: o Underinflated or overinflated tires can cause poor handling, loss of vehicle control, and sudden tire failure leading to accidents, injuries, and even death. Always check tires are properly inflated before driving. o Driving on tires with no or insufficient tread is dangerous. Wornout tires can result in loss of vehicle control, collisions, and injury and even death. Worn-out tires should be replaced as soon as possible and should never be used for driving. Always check tire tread before driving your car. Refer to this page for further information and tread limits.

    When to replace tires
    The original tires on your car have tread wear indicators . The location of tread wear indicators is shown by the "TWI" or "" marks, etc., The tread wear indicators appea ...

    Spare tire and tools
    Your Hyundai is delivered with the following: Spare tire and wheel. Wheel nut wrench, Wrench bar. Jack. ...

    See also:

    LOCK
    The key can only be inserted or removed in this position. The ignition switch will lock the steering wheel when you remove the key. If turning the key is difficult, turn the steering wheel sl ...

    If Your Engine Overheats
    In any of the following situations, you can reduce the potential for overheating your engine by taking the appropriate action. • On the highways — slow down. • In city traffic — while st ...

    Isofix anchor points (not Australia)
    Do not attempt to fit ISOFIX restraints to the centre rear seating position. The anchor bars are not designed to hold an ISOFIX restraint in this position. If the restraint is not correctly a ...