Volvo XC60: Stage 2: Checking inflation pressure - Tire sealing system–temporarily repairing a flat tire - Tire Sealing System - Wheels and tires - Volvo XC60 Owner's ManualVolvo XC60: Stage 2: Checking inflation pressure

1. Connect the tire sealing system as described in stage 1.

2. Refer to the inflation pressure table in this chapter for the correct inflation pressure. If the tire needs to be inflated, start the tire sealing system’s compressor. If necessary, release air from the tire by turning the air release knob counterclockwise.

CAUTION The compressor should not be used for more than 10 minutes at a time to avoid overheating.

WARNING
If you interrupt your trip for more than 1 hour, check the inflation pressure in the damaged tire again before continuing.

    Stage 1: Sealing the hole
    1. Open the cover on the tire sealing kit. 2. Peel off the speed limit sticker and affix it to the steering wheel hub where it will be clearly visible to the driver. 3. Ensure that the on/off sw ...

    Replacing the sealing compound container
    The sealing compound container must be replaced if: • the tire sealing system has been used to repair a tire. • the container’s expiration date has passed (see the date on decal). NOTE ...

    See also:

    FCC and RSS-210 Industry Canada Compliance
    The Car2U system complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, ...

    For owners
    Reporting safety defects for U.S. owners, and seat belt and SRS airbag instructions for Canadian owners ...

    Multi-Band Antenna
    The multi-band antenna is on the roof of the vehicle. The antenna is used for the AM&-FM radio, OnStar, the XM Satellite Radio Service System, and GPS (Global Positioning System), if the vehic ...