Toyota RAV4: Setting automatic connection of the device on or off
If “BT Power” is set to on, the registered device will be connected automatically when the engine switch is turned to the “ACC” position.
1 Select “BT Power” using .
2 Select “ON” or “OFF” using .
Changing the passkey
1 Select “Passkey” using . 2 Select a 4 to 8-digit passkey using . Input the number 1 digit at a time. 3 When the entire number to be registered as a passkey has been input, press again. I ...Displaying the device status
Select “Bluetooth info” using . ● Displaying the device name Select “Device Name” using . ● Displaying the device address Select “Device Address” using . ...See also:
Function
A vehicle towing a trailer may begin to sway for
various reasons. Normally this only occurs at
high speeds but, for example, if the trailer is
overloaded or if the load is unevenly distributed
...
Seat belts
Make sure that all occupants are wearing their seat belts before driving
the vehicle.
■ Correct use of the seat belts
● Extend the shoulder belt so
that it comes fully over the
shou ...
Safety Belt Extender
If the vehicle's safety belt will fasten around you, you should use it.
But if a safety belt is not long enough, your dealer will order you an extender.
When you go in to order it, take the hea ...