Jeep Liberty: Sentry Key - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Sentry Key

The Sentry Key Immobilizer System prevents unauthorized vehicle operation by disabling the engine. The system does not need to be armed or activated. Operation is automatic, regardless of whether the vehicle is locked or unlocked.

The system uses ignition keys that have an embedded electronic chip (transponder) to prevent unauthorized vehicle operation. Therefore, only keys that are programmed to the vehicle can be used to start and operate the vehicle. The system will shut the engine off in two seconds if someone uses an invalid key to try to start the engine.

NOTE: A key that has not been programmed is also considered an invalid key, even if it is cut to fit the ignition switch lock cylinder for that vehicle.

During normal operation, after turning on the ignition switch, the Vehicle Security Light will turn on for three seconds for a bulb check. If the light remains on after the bulb check, it indicates that there is a problem with the electronics. In addition, if the Vehicle Security Light begins to flash after the bulb check, it indicates that someone used an invalid key to try to start the engine.

Either of these conditions will result in the engine being shut off after two seconds.

If the Vehicle Security Light turns on during normal vehicle operation (vehicle running for longer than 10 seconds), it indicates that there is a fault in the electronics.

Should this occur, have the vehicle serviced as soon as possible by an authorized dealer.

CAUTION!
The Sentry Key Immobilizer system is not compatible with some after-market remote starting systems.

Use of these systems may result in vehicle starting problems and loss of security protection.

All of the keys provided with your new vehicle have been programmed to the vehicle electronics.

Key-In-Ignition Reminder
If you open the driver’s door and the key is in the ignition, a chime will sound to remind you to remove the key. NOTE: The Key-In-Ignition reminder only sounds when the ignition key is place ...

Replacement Keys
NOTE: Only keys that are programmed to the vehicle electronics can be used to start and operate the vehicle. Once a Sentry Key is programmed to a vehicle, it cannot be programmed to any other veh ...

See also:

Seek tuning (SEEK)
Type A and B audio: Type C audio: Type D audio: If you press the “” or “” button briefly, the radio will automatically search for a receivable station and stop at the first one ...

How to say numbers
NISSAN Voice Recognition requires a certain way to speak numbers in voice commands. Refer to the rules and examples below. - Either “zero” or “oh” can be used for “0”. Example: 1-800- ...

Standby mode due to action by the driver
ACC is temporarily deactivated and put in standby mode: • when the brakes are applied • if the driver's seat belt is taken off • If the driver's door is opened • if the gear selector is ...