GMC Terrain: Roof Rack System - Storage - GMC Terrain Owner's ManualGMC Terrain: Roof Rack System

WARNING

If something is carried on top of the vehicle that is longer or wider than the roof rack—like paneling, plywood, or a mattress—the wind can catch it while the vehicle is being driven. The item being carried could be violently torn off, and this could cause a collision and damage the vehicle. Never carry something longer or wider than the roof rack on top of the vehicle unless using a GM certified accessory carrier.

This vehicle may be equipped with a roof rack. For roof racks that do not have cross rails included, GM certified cross rails can be purchased as an accessory. See your dealer for additional information.

Notice: Loading cargo on the roof rack that weighs more than 100 kg (220 lbs) or hangs over the rear or sides of the vehicle may damage the vehicle. Load cargo so that it rests evenly between the crossrails, making sure to fasten cargo securely.

To prevent damage or loss of cargo when driving, check to make sure cross rails and cargo are securely fastened. Loading cargo on the roof rack will make the vehicle's center of gravity higher. Avoid high speeds, sudden starts, sharp turns, sudden braking, or abrupt maneuvers; otherwise it may result in loss of control. If driving for a long distance, on rough roads, or at high speeds, occasionally stop the vehicle to make sure the cargo remains in its place. Do not exceed the maximum vehicle capacity when loading the vehicle. For more information on vehicle capacity and loading, see Vehicle Load Limits on page 9‑16.

The roof rack cross rails can be locked in four positions along the roof rack

The roof rack cross rails can be locked in four positions along the roof rack side rails. These are the only positions that the cross rails will lock.

Lift the lever to release and move the cross rail.

Lift the lever to release and move the cross rail.

Position the cross rail on both sides of the vehicle at the same time.

Push the lever down to completely engage into the side rail holes. If the lever

Push the lever down to completely engage into the side rail holes. If the lever is not tight, then the cross rail is not engaged in a side rail hole.

Slide the cross rails back and forth until the lock pins engage in the holes and a click is heard as the pins align and the cross rail locks. Try sliding the cross rails forward and backward to ensure that they are correctly secured and that the levers stay tight to the cross rails. Do not stand on the plastic lower body panels when loading cargo on the roof rack.

When the roof rack is not in use, lock one cross rail at the furthest forward position and lock the other cross rail at the furthest rearward position to reduce wind noise.

    Convenience Net
    This vehicle may have a convenience net located in the rear of the vehicle. Attach it to the cargo tie&-downs for storing small loads. Do not use the net to store heavy loads. ...

    See also:

    Vanity mirrors
    Slide the cover. The light turns on when the cover is opened. ...

    Vehicle Dynamics Control operation indicator light
    The indicator light flashes during activation of the skid suppression function and during activation of the traction control function. NOTE - The light may remain illuminated for a short pe ...

    Adjusting the set speed
    After a speed has been set, it can be increased or decreased by using the or buttons. 1. Press and hold down or until the vehicle reaches the desired speed. > This will become the set ...