Jeep Liberty: Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) —
If Equipped
The following messages will display in the EVIC if the
vehicle fails to remote start or exits remote start prematurely:
• Remote Start Aborted — Door Ajar
• Remote Start Aborted — Hood Ajar
• Remote Start Aborted — L/Gate Ajar
• Remote Start Aborted — System Fault
• Remote Start Aborted — Fuel Low
The EVIC message stays active until the ignition is turned to the ON/RUN position.
How To Use Remote Start
All of the following conditions must be met before the
engine will remote start:
• Shift lever in PARK.
• Doors closed.
• Hood closed.
• Liftgate closed.
• Hazard switch off.
...
To Enter Remote Start Mode
Press and release the REMOTE START button
on the RKE transmitter twice within five seconds.
The parking lights will flash and the horn
will chirp twice (if programmed). Then, the
engine will ...
See also:
Towing a disabled vehicle
Proper towing or lifting equipment is required to prevent
damage to your vehicle. Use of safety chains is recommended.
Attach towing device to main structural members
of the vehicle, not to bump ...
Parksense System Usage Precautions
NOTE:
• Ensure that the rear bumper is free of snow, ice, mud,
dirt and debris to keep the ParkSense system operating
properly.
• Jackhammers, large trucks, and other vibrations could
aff ...
Setup
To switch to system setup, you may say on of the
following:
• “Change to setup”
• “Switch to system setup”
• “Change to setup”
• “Main menu setup” or
• “Switch ...