Range Rover Evoque: Rain sensor

switched off Ensure that the wipers are switched off before entering a car wash. If the rain sensitive wipers operate during the car washing process, damage may occur to the wiper mechanism.

The rain sensor is able to detect the presence and amount of rain/dirt/snow on the windscreen and automatically activates the windscreen wipers accordingly. Static droplets may not be detected on initial start-up, use a single wipe to clear the screen.

To activate the rain sensitivity wipers, move the wiper stalk to the rain sensor position (4). A single wipe will be actioned.

Adjust the rain sensitivity collar (1) as required.

Increasing sensitivity while position (4) is selected will action a single wipe.

If a front door is opened while the wipers are operating, the wipers will be disabled.

Operation will restart when the doors are closed again.

READ NEXT:

 Speed sensitive wipers

If vehicle speed drops below 6km/h (3.7mph) with the wipers operating in positions (2) or (3), the wipers will switch to the next lowest speed. When vehicle speed increases to over 6km/h (3.7mph),

 Drip wipe

If the drip wipe function is configured, the wipers will operate four seconds after a wash/wipe cycle has finished, to clear any remaining drips from the windscreen. This function can be enabled

 Winter park position

The wipers can be set to park in a higher position than normal. This allows the blades to be lifted from the screen to prevent freezing. The ‘Wipers winter park’ option can be selected from th

SEE MORE:

 Rear Wheel Bearing

Special Tool(s) 204-250 Wheel bearing install and removal tool 204-305 Remover, Wheel Bearing 204-726 Remover/Installer, Wheel Bearing JLR-204-806 Support Tool, Wheel Knuckle JLR-204-809 Installer, Rear Wheel Bearing JLR-204-810 Installer, Rear Wheel Bearing General Equipment Copper Hammer Hydrau

 Manual Transmission FWD

Component Location COMPONENT LOCATION Manual transmission Selector lever assembly Overview OVERVIEW The M66EH50 manual transmission is a 6 speed unit manufactured by Getrag-Ford in Cologne, Germany. The transmission is a highly compact 4 shaft design, incorporating the front final drive gear.

© 2011-2024 Copyright www.rrevoque.org