Honda CR-V: Radio Reception

How well the radio receives stations is dependent on many factors, such as the distance from the station’s transmitter, nearby large objects, and atmospheric conditions.

A radio station’s signal gets weaker as you get farther away from its transmitter. If you are listening to an AM station, you will notice the sound volume becoming weaker, and the station drifting in and out. If you are listening to an FM station, you will see the stereo indicator flickering off and on as the signal weakens.

Eventually, the stereo indicator will go off and the sound will fade completely as you get out of range of the station’s signal.

Driving very near the transmitter of

Driving very near the transmitter of a station that is broadcasting on a frequency close to the frequency of the station you are listening to can also affect your radio’s reception.

You may temporarily hear both stations, or hear only the station you are close to.

Radio signals, especially on the FM

Radio signals, especially on the FM band, are deflected by large objects such as buildings and hills. Your radio then receives both the direct signal from the station’s transmitter, and the deflected signal. This causes the sound to distort or flutter. This is a main cause of poor radio reception in city driving.

Radio reception can be affected by

Radio reception can be affected by atmospheric conditions such as thunderstorms, high humidity, and even sunspots. You may be able to receive a distant radio station one day and not receive it the next day because of a change in conditions.

Electrical interference from passing vehicles and stationary sources can cause temporary reception problems.

As required by the FCC:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

READ NEXT:

 Protecting Your Discs

 General Information

When using CD-R or CD-RW discs, use only high quality discs labeled for audio use. When recording a CD-R or CD-RW, the recording must be closed for it to be used by the system. Play only s

 Protecting Discs

When a disc is not being played, store it in its case to protect it from dust and other contamination. To prevent warpage, keep discs out of direct sunlight and extreme heat. To clean a disc,

SEE MORE:

 Memorizing the Tire Pressure Sensor ID

Special Tools Required TPMS sensor initializer tool AKS0620006 Available through the American Honda Tool and Equipment program, 888-424-6857. All four tire pressure sensor IDs must be memorized to the TPMS control unit whenever you do any of these actions: Replace the TPMS control unit. Replace

 DTC P0443: EVAP Canister Purge Valve Circuit Malfunction

Special Tools Required Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A or equivalent, commercially available. NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC wi

© 2016-2024 Copyright www.hcrv.net