Honda CR-V: Power Windows - Instruments and Controls - Honda CR-V Owner's ManualHonda CR-V: Power Windows

Turn the ignition switch to the ON

Turn the ignition switch to the ON (II) position to raise or lower any window. To open the window, push the switch down and hold it. Release the switch when you want to stop the window. To close the window, pull back on the switch and hold it.

The windows will operate for up to 10 minutes after you turn off the ignition switch. Opening either front door cancels this function.

Closing a power window on

Closing a power window on someone’s hands or fingers can cause serious injury.

Make sure your passengers are away from the windows before closing them.

AUTO - To open or close the driver’s window, push or pull the window switch firmly down or up to the second detent, and release it.

The window will automatically go up or down all the way. To stop the window, pull or push the window switch briefly.

When you push the MAIN switch in, the switch is off, and the passenger windows cannot be raised or lowered.

To cancel this feature, push on the switch again to get it to pop out.

Keep the MAIN switch off when you have children in the vehicle so they do not injure themselves by operating the windows unintentionally.

AUTO REVERSE - If the driver’s window senses any obstacle while it is closing automatically, it will reverse direction, and then stop. To close the window, remove the obstacle, then use the window switch again.

Auto reverse stops sensing when the window is almost closed. You should always check that all passengers and objects are away from the window before closing it.

NOTE: The driver’s window auto reverse function is disabled when you continuously pull up the switch.

    Seat Heaters
    If equipped Both front seats are equipped with seat heaters. The passenger seat only has heaters in the seat bottom because of the side airbag cutoff system. The ignition switch must ...

    Moonroof
    If equipped The moonroof can be tilted up in the back for ventilation, or it can be slid back into the roof. Use the switch on the front ceiling to operate the moonroof. You must turn the ...

    See also:

    Stage 2: Checking inflation pressure
    1. Connect the tire sealing system as described in stage 1. 2. Refer to the inflation pressure table in this chapter for the correct inflation pressure. If the tire needs to be inflated, start ...

    Charging System Light
    The charging system light comes on briefly when the ignition is turned on, but the engine is not running, as a check to show the light is working. The light turns off when the engine is started. ...

    Conserving electrical current
    Keep the following in mind to help minimize battery drain: • When the engine is not running, avoid using ignition mode II. Many electrical systems (the audio system, the optional navigation ...