Jeep Liberty: Onboard Diagnostic System — OBD II
Your vehicle is equipped with a sophisticated onboard diagnostic system called OBD II. This system monitors the performance of the emissions, engine, and automatic transmission control systems. When these systems are operating properly, your vehicle will provide excellent performance and fuel economy, as well as engine emissions well within current government regulations.
If any of these systems require service, the OBD II system will turn on the “Malfunction Indicator Light (MIL).” It will also store diagnostic codes and other information to assist your service technician in making repairs. Although your vehicle will usually be drivable and not need towing, see your authorized dealer for service as soon as possible.
CAUTION!
• Prolonged driving with the MIL on could cause
further damage to the emission control system. It
could also affect fuel economy and drivability. The
vehicle must be serviced before any emissions
tests can be performed.
• If the MIL is flashing while the engine is running, severe catalytic converter damage and power loss will soon occur. Immediate service is required.
Engine Compartment — 3.7L
1 — Air Cleaner Filter 2 — Engine Oil Dipstick 3 — Brake Fluid Reservoir 4 — Integrated Power Module (Fuses) 5 — Battery 6 — Washer Fluid Reservoir 7 — Engine Coolant Reser ...Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel filler cap is loose, improperly installed, or damaged, a “gASCAP” message will display in the odometer or a “CHECK gASCAP” messa ...See also:
Door open warning light
The door open warning light illuminates if
any door or the rear gate is not fully
closed.
Always make sure this light is out before
you start to drive. ...
Remote Start Heated Seats
When it is cold outside, the heated seats can be programmed to turn on automatically
during a remote vehicle start. The heated seats will be canceled when the ignition
is turned on. Press the heat ...
Engine Speed Limiter
If you exceed the maximum speed
for the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may feel
the engine cut in and out. This is
caused ...