Honda CR-V: Mode Control - Vents, Heating, and A/C - Features - Honda CR-V Owner's ManualHonda CR-V: Mode Control

Use the mode control buttons to select the vents air flows from. Some air will flow from the dashboard corner vents in all modes.

Air flows from the center

Air flows from the center and corner vents in the dashboard.

Airflow is divided between

Airflow is divided between the vents in the dashboard and the floor vents.

Air flows from the floor

Air flows from the floor vents.

When you select automatically switches to fresh air, the system automatically switches to fresh air mode. If you switch the mode from to or , the system to keeps the A/C on. The A/C, the system keeps the A/C on. The A/C indicator will not come on if it was off to start with.

To turn off the A/C, press the A/C button to illuminate the indicator, then press it again to turn off the A/C.

When you switch to or mode from mode from turns off. But if it was on to start, the A/C turns off. But if it was on to start with, the A/C stays on.

the floor vents and defroster vents at Airflow is divided between the floor vents and defroster vents at the base of the windshield.

vents at the base of the windshield. Air flows from the defroster vents at the base of the windshield.

When you select , or the system automatically switches to, the system automatically switches to fresh air mode and turns on the A/C.

You cannot turn the A/C off in this mode.

    Vents, Heating, and A/C
    Vents, Heating, and A/C Fan Control Dial Turn this dial to increase or decrease the fan speed and airflow. Temperature Control Dial Turning this dial clockwise increases the temperature of ...

    Ventilation
    The flow-through ventilation system draws in outside air, circulates it through the interior, then discharges it through vents near the tailgate. 1. Set the temperature to the lower limit. 2 ...

    See also:

    Tire Pressure Monitoring System (TPMS) - Required Federal Explanation
    Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by the vehicle manufacturer on the vehicle placard or tir ...

    Connecting cell phones
    The procedure for connecting a cell phone varies, depending on the phone itself and on whether or not the phone has been previously paired with the infotainment system (see page 231 for instru ...

    Drive selector
    P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw ...