Honda CR-V: Mirrors - Instruments and Controls - Honda CR-V Owner's ManualHonda CR-V: Mirrors

Keep the inside and outside mirrors

Keep the inside and outside mirrors clean and adjusted for best visibility.

Be sure to adjust the mirrors before you start driving.

The inside mirror has day and night positions. The night position reduces glare from headlights behind you.

Flip the tab on the bottom edge of the mirror to select the day or night position.

Adjusting the Power Mirrors

1. Turn the ignition switch to the ON

1. Turn the ignition switch to the ON (II) position.

2. Move the selector switch to L (driver’s side) or R (passenger’s side).

3. Push the appropriate edge of the adjustment switch to move the mirror right, left, up, or down.

4. When you finish, move the selector switch to the center (off) position. This turns the adjustment switch off to keep your settings.

Power Mirror Heaters

If equipped

If equipped

The outside mirrors are heated to remove fog and frost. With the ignition switch in the ON (II) position, turn on the heaters by pressing the button. The indicator in the button comes on as a reminder.

Press the button again to turn the heaters off. Pressing this button also turns the rear window defogger on and off.

    Moonroof
    If equipped The moonroof can be tilted up in the back for ventilation, or it can be slid back into the roof. Use the switch on the front ceiling to operate the moonroof. You must turn the ...

    Interior Convenience Items
    Interior Convenience Items ...

    See also:

    Speed sensitive wipers
    If vehicle speed drops below 6km/h (3.7mph) with the wipers operating in positions (2) or (3), the wipers will switch to the next lowest speed. When vehicle speed increases to over 6km/h (3.7mph), ...

    Electronic compass (if equipped)
    The compass heading is displayed in the center stack display. The compass reading may be affected when you drive near large buildings, bridges, power lines and powerful broadcast antenna. Magnetic ...

    Rds-tmc display
    When a TMC signal is received the icon in the top left of the screen will appear green. If a TMC signal is not being received, the icon will be shown with a bar through it. The system will inform ...