Range Rover Evoque: Memory seats
Front seat positions can be saved to vehicle memory.
Once you have adjusted the power operated driver’s seat and the exterior mirrors, the vehicle can memorise the settings for future use. See 48, EXTERIOR MIRRORS.
1. On the driver’s seat, press the memory store button to activate the memory function. The switch indicator will illuminate.
2. Press one of the preset buttons within 5 seconds to memorise the current settings.
Memory (1, 2 or 3) Settings Saved will be displayed on the message centre, accompanied by an audible chime to confirm the settings have been saved to memory.
Note: A seat position will be saved to memory only during the 5 second active period.
Note: Any existing settings will be over-written when a new position is saved to memory.
To recall a saved position, press the relevant preset button (2). Memory (1, 2 or 3) Recalled will be displayed in the message centre.
For the passenger seat of a Coupe model, press the memory button to store the current settings. If the seat adjustment is subsequently changed, press the memory button to restore the original settings.
READ NEXT:
Easy entry/exit
When Easy entry/exit is configured, the driver’s
seat will automatically lower when the ignition
is switched off and the door release lever is
used. Upon returning to the vehicle, when the
drive
Head restraints
Adjust the head restraint so
that the
top of the head restraint is above the
centre line of the head. An incorrectly
adjusted head restraint increases the
risk of death or serious injury in the
Integrated head restraints
Models with ‘sports’ seats have non adjustable
and non removable head restraints.
SEE MORE:
Clutch
Lubricants, Fluids, Sealers and Adhesives
General Specification
Torque Specifications
* Tighten bolts progressively by diagonal selection.
Clutch Disc and Pressure Plate Vehicles With: M66 6-Speed Manual
Transmission AWD
Special Tool(s)
303-1272
Locking Tool, Flywheel
308-667
Aligner, Clutch
Remo
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6 inches) away from
the HomeLink transceiver in the rear-view
mirror, keeping the indicator lamp in
