Nissan Rogue: Making a call by entering a phone number - Getting started - Bluetooth® Hands-Free Phone System (if so equipped) - Center display, heater, air conditioner, audio, phone 
and voice recognition systems - Nissan Rogue Owner's ManualNissan Rogue: Making a call by entering a phone number

1. Push the  button on steering

1. Push the wheel. A button on steering wheel. A tone will sound.

2. Say: “Call” A . The system acknowledges the command and announces the next set of available commands.

3. Say: “Phone Number” B . The system acknowledges the command and announces the next set of available commands.

Say: “Special Dialing” to dial more than 10 digits or any special characters.

4. Say the number you wish to call starting with the area code in single digit format. If the system has trouble recognizing the correct phone number, try entering the number in the following groups: 3-digit area code, 3- digit prefix and the last 4-digits. For example, 555-121-3354 can be said as “five five five” as the 1st group, then “one two one” as the 2nd group, and “three three five four” as the 3rd group. For dialing more than 10 digits or any special characters, say “Special Dialing”.

See “How to say numbers” earlier in this section, for more information.

5. When you have finished speaking the phone number, the system repeats it back and announces the available commands.

6. Say: “Dial” C . The system acknowledges the command and makes the call.

For additional command options, see “List of voice commands” later in this section.

    Connecting procedure
    NOTE: The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled. 1. Push the button on t ...

    Receiving a call
    When you hear the ring tone, push the button on the steering wheel. Once the call has ended, push the button on the steering wheel. NOTE: If you do not wish to take the call when you he ...

    See also:

    Leaving After Parking on a Hill
    1. Apply and hold the brake pedal. 2. Start the engine. 3. Shift into a gear. 4. Release the parking brake. 5. Let up on the brake pedal. 6. Drive slowly until the trailer is clear of the chocks. ...

    Using the cover
    Using the cover To extend the cover, pull the end of the cover out of the housing, then insert its hooks into the catches as shown. To rewind it, unhook it from the catches and it will re ...

    Turn signal lever
    1 Right turn 2 Left turn 3 Move and hold the lever partway to signal a lane change. The right hand signal will flash until you release the lever. 4 Move and hold the lever partway to signal ...