Jeep Liberty: Intermittent Wiper System
Use the intermittent wiper system when weather conditions make a single wiping cycle with a variable pause between cycles desirable. Rotate the end of the windshield wiper/washer control lever to the first detent, and then turn the end of the lever to select the desired delay interval.
Front Wiper Control
There are five delay settings, which allow you to regulate the wipe interval from a minimum of one cycle every second to a maximum of approximately 36 seconds between cycles or from a minimum of one cycle every second to a maximum of approximately 18 seconds between cycles at vehicle speeds greater than 10 mph (16 km/h).
NOTE: The wiper delay times depend on vehicle speed.
If the vehicle is moving less than 10 mph (16 km/h), delay times will be doubled.
Windshield Wiper Operation
Rotate the end of the lever upward to the second detent
past the intermittent settings for low-speed wiper operation.
Rotate the end of the lever upward to the third detent
past the intermittent ...
Windshield Washers
To use the washer, pull the windshield wiper/washer
control lever toward you and hold it for as long as
washer spray is desired (for a maximum of 10 seconds).
If you activate the washer while the ...
See also:
Displaying and selecting preset stations (type D audio)
1. Press the button for 1.5
seconds
or longer during satellite radio reception to
display the radio screen.
2. Operate the “TUNE/TRACK/CH” dial
to select the stations. ...
Engine oil and oil filter
Checking the engine oil level 1. Be sure the vehicle is on level ground. 2. Start
the engine and allow it to reach normal operating temperature. 3. Turn the engine
off and wait for a few minut ...
Tire and Loading Information Label
Label Example
A vehicle specific Tire and Loading Information label is attached to the vehicle's
center pillar (B-pillar). With the driver's door open, you will find the label attached
...