Volvo XC60: Installation
1. Lower the battery into the battery box.
2. Move the battery inward and to the side until it reaches the rear edge of the box.
3. Tighten the clamp that secures the battery.
4. Connect the ventilation hose.
> Be sure that it is correctly connected to the battery and the vent in the vehicle's body.
5. Connect the red positive cable.
6. Connect the black negative cable.
7. Press in the rear cover. (See Removal).
8. Reinstall the molding. (See Removal).
9. Reinstall the front cover and secure it with the clips. (See Removal).
Removal
Switch off the ignition, remove the remote key from the ignition slot and wait at least 5 minutes before disconnecting the battery so that all information in the vehicle's electrical system ca ...Fuses
...See also:
If the front passenger’s frontal airbag ON indicator illuminates and the OFF
indicator turns off even when an infant or a small child is in a child restraint
system (including booster seat)
Turn the ignition switch to the “LOCK”
position if the front passenger’s frontal
airbag ON indicator illuminates and the
OFF indicator turns off even when an
infant or a small child is i ...
Load anchoring eyelets
The load anchoring eyelets on both sides of the
vehicle are used to fasten straps, etc., to help
anchor items in the cargo area.
WARNING
• Cover sharp edges on long loads to help
prevent i ...
Resetting the side windows
You must reset each side window if a side window can no longer be closed fully.
Close all the doors.
Turn the SmartKey to position 1 or 2 in the ignition lock.
Pull the corresponding switch on ...