Nissan Rogue: Inside mirror
Inside mirror
Adjust the height and the angle of the inside mirror to the desired position.
Manual anti-glare type
The night position 1 will reduce glare from the headlights of vehicles behind you at night.
Use the day position 2 when driving in daylight hours.
Use the night position only when necessary, because it reduces rear view clarity.
Automatic anti-glare type
The inside mirror is designed so that it automatically changes reflection according to the intensity of the headlights of the following vehicle.
The anti-glare system will be automatically turned on when the ignition switch is turned to the ON position.
Type A:
When the system is turned on, the indicator light A will illuminate and excessive glare from the headlights of the vehicle behind you will be reduced.
Push the switch B to make the inside rearview mirror operate normally and the indicator light will turn off. Push the switch again to turn the system on.
Do not allow any object to cover the sensors C or apply glass cleaner on them. Doing so will reduce the sensitivity of the sensors, resulting in improper operation.
For the compass operation, see “Compass” in the “2. Instruments and controls” section.
For the HomeLink® Universal Transceiver operation, see “HomeLink® Universal Transceiver” in the “2. Instruments and controls” section.
Type B:
When the system is turned on, the indicator light A will illuminate and excessive glare from the headlights of the vehicle behind you will be reduced.
Push the switch B for 3 seconds to make the inside mirror operate normally and the indicator light will turn off. Push the switch again for 3 seconds to turn the system on.
Do not hang any objects on the mirror or apply glass cleaner. Doing so will reduce the sensitivity of the sensor C , resulting in improper operation.
Mirrors
...Outside mirrors
Outside mirrors Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an acci ...See also:
To Play a PC Card
You operate the PC card player with
the same controls used for the radio
and the disc player. To load or play a
card, the ignition switch must be in
the ACCESSORY (I) or ON (II)
position.
T ...
Brow of hill
When driving up an uphill gradient, slightly reduce pressure on the accelerator
immediately before reaching the brow of the hill. Use the vehicle's own impetus
to drive over the top of the hil ...
Parking brake
To set the parking brake, depress the
brake pedal firmly and hold it down until
the parking brake lever is fully pulled up.
To release the parking brake, pull the lever
up slightly, press t ...