Honda CR-V: How the SRS Indicator Works - Additional Information About Your Airbags - Driver and Passenger Safety - Honda CR-V Owner's ManualHonda CR-V: How the SRS Indicator Works

The SRS indicator alerts you to a

The SRS indicator alerts you to a potential problem with your airbags or seat belt tensioners.

When you turn the ignition switch to the ON (II) position, this indicator comes on briefly then goes off. This tells you the system is working properly.

If the indicator comes on at any other time, or does not come on at all, you should have the system checked by your dealer. For example:

If the SRS indicator does not come on after you turn the ignition switch to the ON (II) position.

If the indicator stays on after the engine starts.

If the indicator comes on or flashes on and off while you drive.

If you see any of these indications, the airbags and seat belt tensioners may not work properly when you need them.

Ignoring the SRS indicator can

Ignoring the SRS indicator can result in serious injury or death if the airbag systems or tensioners do not work properly.

Have your vehicle checked by a dealer as soon as possible if the SRS indicator alerts you to a possible problem.

    How Your Side Curtain Airbags Work
    In a Side Impact In a moderate to severe side impact, sensors will detect rapid acceleration and signal the control unit to instantly inflate the side curtain airbag. If the impact is on ...

    How the Side Airbag Off Indicator Works
    This indicator alerts you that the passenger’s side airbag has been automatically shut off. It does mean there is a problem with your side airbags. not When you turn the ignition switc ...

    See also:

    Tire Spinning
    When stuck in mud, sand, snow, or ice conditions, do not spin your vehicle’s wheels above 30 mph (48 km/h). WARNING! Fast spinning tires can be dangerous. Forces generated by excessive wheel ...

    Rear Window Wiper/Washer
    The rear wiper controls are on the end of the windshield wiper lever. ON: Press the upper portion of the button for continuous rear window wipes. OFF: The rear wiper turns off when the button is r ...

    Starting procedure with the SmartKey
    To start the engine using the SmartKey instead of KEYLESS-GO, pull the Start/ Stop button out of the ignition lock. X Turn the SmartKey to position 3 in the ignition lock () and release it as ...