Jeep Liberty: Heated Seats — If Equipped - Seats - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Heated Seats — If Equipped

On some models, the front driver and passenger seats may be equipped with heaters in both the seat cushions and seatbacks.

There are two heated seat switches that allow the driver and passenger to operate the seats independently. The controls for each seat are located on a switch bank near the bottom center of the instrument panel.

You can choose from HIGH, LOW or OFF heat settings.

Amber indicator lights in each switch indicate the level of heat in use. Two indicator lights will illuminate for HIGH, one for LOW and none for OFF.

Press the switch once to select HIGH-level

Press the switch once to select HIGH-level heating. Press the switch a second time to select LOW-level heating. Press the switch a third time to shut the heating elements OFF.

When the HIGH-level setting is selected, the heater will provide a boosted heat level during the first four minutes of operation. Then, the heat output will drop to the normal HIGH-level. If the HIGH-level setting is selected, the system will automatically switch to LOW-level after approximately 30 minutes of continuous operation. At that time, the number of illuminated LEDs changes from two to one, indicating the change. The LOW-level setting will turn OFF automatically after approximately 30 minutes.

NOTE: When a heat setting is selected, heat will be felt within two to five minutes.

WARNING!
• Persons who are unable to feel pain to the skin because of advanced age, chronic illness, diabetes, spinal cord injury, medication, alcohol use, exhaustion or other physical condition must exercise care when using the seat heater. It may cause burns even at low temperatures, especially if used for long periods of time.

• Do not place anything on the seat that insulates against heat, such as a blanket or cushion. This may cause the seat heater to overheat. Sitting in a seat that has been overheated could cause serious burns due to the increased surface temperature of the seat.

    Driver’s Power Seat — If Equipped
    The power seat switch is located on the outboard side of the seat near the floor. Use this switch to move the seat up or down, forward or rearward or to tilt the seat. Power Seat Switch Adjust ...

    Manual Front Seat Adjustments
    For models equipped with manual seats, the driver and passenger seats can be adjusted forward or rearward by using a bar by the front of the seat cushion, near the floor Manual Seat Adjustment ...

    See also:

    Activating/deactivating warning signals
    The collision warning system’s visual signals are activated automatically when the engine is started if the collision warning system is switched on. The audible warning signal can be activate ...

    Smart key check
    If the ignition is on or the engine is running and there is no Smart Key inside the vehicle when the last door is closed, the message Smart Key Not Found Refer to Handbook will be displayed in the ...

    Turn signals
    High-beam headlamps ight turn signal High-beam flasher Left turn signal To indicate briefly: press the combination switch briefly to the pressure point in the direction of arrow 2 ...