Jeep Liberty: Hazard Warning Flashers
The Hazard Warning flasher switch is located in the switch bank below the climate controls.
Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flashers.
This is an emergency warning system and it should not be used when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.
When you must leave the vehicle to seek assistance, the Hazard Warning flashers will continue to operate even though the ignition is placed in the OFF position.
NOTE: With extended use the Hazard Warning flashers may wear down your battery.
If Your Engine Overheats
In any of the following situations, you can reduce the
potential for overheating your engine by taking the
appropriate action.
• On the highways — slow down.
• In city traffic — while st ...
See also:
Manual command selection
Commands can be selected manually. While the
commands are displayed on the audio screen,
select a command by operating the audio tuning
switch, and then push the switch.
Once a
command is m ...
DOOR position
When the switch is in the DOOR position 2
the map lights will illuminate under the following
conditions:
- ignition switch is turned to the LOCK
position
— remain on for about 15 seconds. ...
XM Messages
XL (Explicit Language Channels): These channels, or any others, can be blocked
by request, by calling 1-800-929-2100 in the U.S. and 1-877-438-9677 in Canada.
XM Updating: The encryption code in th ...