Range Rover Evoque: Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener or entry gate,
ensure the area is clear. This will
prevent potential harm or damage as
the gate or garage door will activate
during the programme.
This device may suffer from
interference if operated in the vicinity of
a mobile or fixed station transmitter.
This interference is likely to affect the
hand-held transmitter as well as the
in-car transceiver.
This feature is also known as the HomeLink®
Universal Transceiver. See 55, INFORMATION
AND ASSISTANCE.
The HomeLink transceiver is located in the rear
view mirror. It can be programmed to transmit
the radio frequencies of up to three different
transmitters, which can be used to operate
garage doors, entry gates, home lighting,
security systems or other radio frequency
operated devices.
Although this section mainly describes the
procedures for a garage door opener, it equally
applies to the previously mentioned
applications.
READ NEXT:
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage d
SEE MORE:
Never drive your vehicle if
the tyre
pressures are incorrect.
Pressure checks should only be
carried out when the tyres are cold,
and the vehicle has been stationary
for more than three hours. A hot tyre
at, or below, recommended cold
inflation pressure, is dangerously
under-inflated.
If
After selecting Points of interest from the
menu, touch Name to input the POI name, for
example, Petrol to display fuel stations on the
map, or touch List for a list of POIs.
Alternatively, choose Category to see all
categories of POI and make your selection.
Use the scroll arrows to change pa
© 2011-2024 Copyright www.rrevoque.org