Range Rover Evoque: Fuse box locations
Fuse box locations
When a fuse box lid is
removed, take
care to protect the box from moisture,
and refit the lid at the earliest
opportunity.
Engine compartment - fuse box access:
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
3. Delatch the tabs. The fuse box can now be
opened.
The engine compartment fuse numbers and
positions are shown on the inside of the fuse
box cover.
Passenger compartment - fuse box access.
There are two covers.
4. To access the upper part, open the
glovebox and remove the panel from the
glovebox liner. A label on the panel shows
the circuits protected and the fuse
locations.
5. To access the lower part, remove the lower
access panel.
Luggage compartment - fuse box access:
6. Remove the panel from the left side trim of
the luggage compartment.
READ NEXT:
Always turn off the ignition
system and
the affected electrical circuit, before
replacing a fuse.
Fit Land Rover approved replacement
fuses of the same rating and type, or
fuses of matching sp
SEE MORE:
TRANSMISSION CONTROL MODULE (TCM)
TCM
Neutral 'N' position
Park 'P' position
Position sensor/manual shaft
Electrical connector
The TCM is located on the top of the transmission casing and is connected on
the high speed CAN (controller area network)
bus to send and receive information to and
Cup holders and storage
1. Glovebox.
2. Inside the glovebox is a drop down storage
area for the Owner’s Handbook pack.
3. Cubby box.
4. Sliding top to reveal cup holders.
Do not drink, or use the
drinks
holders when driving.
5. Rear armrest storage and cup holders.
6. Storage areas.
© 2011-2024 Copyright www.rrevoque.org