Subaru Forester: Front seatbelts - Fastening the seatbelt - Seatbelts - Seat, seatbelt and SRS airbags - Subaru Forester Owner's ManualSubaru Forester: Front seatbelts

1. Adjust the seat position according to the following procedure.

Driver’s seat: Adjust the seatback to the upright position. Move the seat as far from the steering wheel as practical while still maintaining full vehicle control.

Front passenger’s seat: Adjust the seatback to the upright position. Move the seat as far back as possible.

2. Sit well back in the seat.

3. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly after giving it a strong pull, then pull it out slowly again.

4. Insert the tongue plate into the buckle

4. Insert the tongue plate into the buckle until you hear a click.

5. To make the lap part tight, pull up on

5. To make the lap part tight, pull up on the shoulder belt.

6. Place the lap belt as low as possible on your hips, not on your waist.

    Fastening the seatbelt
    - Never use a belt that is twisted or reversed. In an accident, this can increase the risk or severity of injury. - Keep the lap belt as low as possible on your hips. In a collision, th ...

    Adjusting the front seat shoulder belt anchor height
    Adjusting the front seat shoulder belt anchor height The shoulder belt anchor height should be adjusted to the position best suited for the driver/front passenger. Always adjust the anchor he ...

    See also:

    If your vehicle overheats
    If your engine overheats: 1 Stop the vehicle in a safe place and turn off the air conditioning system. 2 Check to see if steam is coming out from under the hood. If you see steam: Stop the engine ...

    SRS airbag system monitors
    Type A Type B A diagnostic system continually monitors the readiness of the SRS airbag system (including front seatbelt pretensioners) while the vehicle is being driven. The SRS airbag s ...

    Preparing the cargo net
    The cargo net can be used in two different positions (behind the B-pillar or the C-pillar). The brackets behind B-pillar : are required for the cargo compartment enlargement (). The corresp ...