Rear Tail/Stop, Turn Signal, And Back-Up Lamp

1. Open the liftgate. 2. Remove the screws that fasten the taillamp housing to the vehicle. 3. Pull the taillamp housing straight back to separate it from the vehicle. 4. Disconnect the elect ...

Fluids, Lubricants, And Genuine Parts

...

See also:

When “CHECK DEVICE” is displayed
This message is displayed under the following conditions. - When there is a short in the USB bus - When a non-corresponding device (for example a USB mouse) is connected - When a non-correspo ...

Important safety notes
You will find an illustration of the instrument cluster in the "At a glance" section (). WARNING A driver's attention to the road and traffic conditions must always be his/her ...

Reporting safety defects in the U.S.
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTS ...