Toyota RAV4: Flattening front seatbacks
The front seats can be moved into a flat seat arrangement.
Manual seat
1 Slide the second seats as far back as possible.
2 Remove the front head restraint.
Slide the front seat further forward than the front-most lock position.
Pull the seatback angle adjustment lever up to unlock and push down the seatback. After returning the seat to its original position, be certain to replace the head restraint.
Power seat
1 Slide the second seats as far back as possible.
2 Remove the front head restraint.
Push the seat position adjusting switch forward to slide the seat to the front-most position.
Move the seatback angle adjusting switch backward to flatten the seatback. After returning the seat to its original position, be certain to replace the head restraint.
Front seats
Manual seat 1 Seat position adjustment lever 2 Seatback angle adjustment lever 3 Vertical height adjustment lever (driver’s side only) Power seat (driver’s side only) 1 Seat position a ...Active head restraints
When the occupant’s lower back presses against the seatback during a rear-end collision, the head restraint moves slightly forward and upward to help reduce the risk of whiplash on the seat ...See also:
Please bear the following in mind
The engine oils are matched to the performance of Mercedes-Benz
engines and service intervals. You should therefore only use engine oils and oil
filters that are approved for vehicles with mainten ...
Positions for towing hitch receiver and hitch ball
1 Weight carrying ball position:
41.4 in. (1051.1 mm)
2 Hitch receiver pin hole position:
32.4 in. (821.8 mm) ...
Front power seat adjustment
Operating tips:
- The seat motor has an auto-reset overload
protection circuit. If the motor stops during
operation, wait for a while, then reactivate
the switch.
- Do not operate the power se ...