Range Rover Evoque: Engine starting: automatic transmission
1. A valid Smart Key must be inside the
vehicle.
2. Make sure the gear selector is in P or N.
3. Firmly depress the brake pedal.
4. Press and release the start button. The
engine will crank automatically until it
starts. For diesel engined vehicles there
may be a delay while the glow plugs warm
up, then the engine will crank automatically
until it starts.
READ NEXT:
Note: Do not press the accelerator pedal when
starting the engine.
1. A valid Smart Key must be inside the
vehicle.
2. Fully depress the clutch pedal.
3. Press and release the start button. For
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
SEE MORE:
The front seats tilt and power slide forwards for
entry to and exit from the rear seats. Operation
is controlled by a lever and switch.
1. Lift the locking lever and pivot the seatback
forwards.
2. Press the front of the switch to power the
seat forwards.
3. To return the seat, pivot the se
TRANSMISSION CONTROL MODULE (TCM)
TCM
Neutral 'N' position
Park 'P' position
Position sensor/manual shaft
Electrical connector
The TCM is located on the top of the transmission casing and is connected on
the high speed CAN (controller area network)
bus to send and receive information to and
© 2011-2024 Copyright www.rrevoque.org