Jeep Liberty: Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded three-wire extension cord.
The engine block heater cord is found under the hood clipped to the heater line on the left side of the engine.
The engine block heater must be plugged in at least one hour to have an adequate warming effect on the engine.
WARNING!
Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt AC
electrical cord could cause electrocution.
After Starting
The idle speed will automatically decrease as the engine warms up. ...Automatic Transmission
CAUTION! Damage to the transmission may occur if the following precautions are not observed: • Shift into PARK only after the vehicle has come to a complete stop. • Shift into or out of RE ...See also:
Storing and Deleting Phone Numbers
The system can store up to 30 phone numbers as name tags in the Hands&-Free Directory
that is shared between the Bluetooth and OnStar systems.
The following commands are used to delete and stor ...
Attaching child safety seats with LATCH (Lower Anchors andTethers for CHildren) attachments
The LATCH system is composed of three vehicle anchor points: two (2)
lower anchors located where the vehicle seat back and seat cushion meet
(called the “seat bight”) and one (1) top tether anch ...
Unable to Connect to OnStar Message
If there is limited cellular coverage or the cellular network has reached maximum
capacity, this message may come on. Push Q to try the call again or try again after
driving a few miles into anoth ...