Jeep Liberty: Emergency Assistance
If you are in an emergency and the mobile phone is reachable:
• Pick up the phone and manually dial the emergency number for your area.
If the phone is not reachable and the Uconnect™ Phone is operational, you may reach the emergency number as follows:
• Press the button to begin.
• After the “Ready” prompt and the following beep, say “Emergency” and the Uconnect™ Phone will instruct the paired mobile phone to call the emergency number.
This feature is supported in the U.S., Canada, and Mexico.
NOTE:
• The emergency number dialed is based on the country
where the vehicle is purchased (911 for the U.S. and
Canada and 060 for Mexico). The number dialed may
not be applicable with the available mobile service and
area.
• If supported, this number may be programmable on some systems. To do this, press the button and say “Setup”, followed by “Emergency”.
• The Uconnect™ Phone does slightly lower your chances of successfully making a phone call as to that for the mobile phone directly.
WARNING!
To use your Uconnect™ Phone System in an emergency,
your mobile phone must be:
• turned on,
• paired to the Uconnect™ System,
• and have network coverage.
Language Selection
To change the language that the Uconnect™ Phone is using: • Press the button to begin. • After the “Ready” prompt and the following beep, say the name of the language you wish to swit ...Towing Assistance
If you need towing assistance: • Press the button to begin. • After the “Ready” prompt and the following beep, say “Towing Assistance”. NOTE: • The towing assistance number dia ...See also:
Epb manual use
Epb manual use
1. To apply the parking brake, with the vehicle
stationary, pull up the lever and release it.
The parking brake warning
lamp will illuminate. It is
important to confirm that th ...
Cleaning the rear view camera
Use clear water and a soft cloth to clean camera lens 1.
Do not clean the camera lens and the area around the rear view camera with
a power washer. ...
Checking the coolant level
Only check the coolant level when the vehicle is on a level surface and the engine
has cooled down.
Turn the SmartKey to position 2 () in the ignition lock. On
vehicles with KEYLESS-GO, press ...