Range Rover Evoque: Commandshift™
To return to Sport mode after CommandShift
has been selected, move the selector back to D
then back to Sport mode. Transmission
Commandshift Selected will appear in the
message centre when the transmission is in
CommandShift mode.
Note: In order to protect the engine, the
transmission will automatically change up to
prevent over-revving, or down if the engine is
labouring.
READ NEXT:
Push the accelerator pedal fully down to
achieve rapid acceleration in automatic mode.
When the pedal is relaxed, normal gear
changing will resume.
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is sw
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
SEE MORE:
Removing the nearside bulbs;
To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb housing. Turn it counter
clockwise to release.
2. To remove the side lamp bulb housing.
Turn it count
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. WARNING: To avoid accidental deployment, the restraints
control module backup power supply must
© 2011-2024 Copyright www.rrevoque.org