Range Rover Evoque: Bulb check
A warning lamp bulb check is initiated when the
ignition system is switched on and lasts for 3
seconds (except for the airbag warning lamp
which will remain on for 6 seconds). If any
warning lamp remains on after this period,
investigate the cause before driving.
Some warning lamps have associated
messages displayed on the message centre.
Note: Not all warning lamps are included in the
check (e.g. high beam headlamps and direction
indicators).
READ NEXT:
Critical warning message (red)
Illuminates when a critical warning
message is available in the
message centre.
Low oil pressure (red)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp remains on, flashes or
illuminates while driving, stop the v
Brake systems (red)
Illuminates briefly when the
ignition is switched on. If the lamp
illuminates while driving, suspect
low brake fluid level or a fault with the
Electronic Brake Distribution
SEE MORE:
NOTES:
A = Hardwired; N = Medium Speed CAN (controller area network) bus; D =
High Speed CAN bus; T = Coaxial; O =
LIN (local interconnect network) bus; P = Fibre Optic MOST; AD = NSTC; AE = LVDS;
Park assist is not available to all markets.
CONTROL DIAGRAM - SHEET 1 OF 3 - PARKING AID AND PARK ASS
Hydraulic Brake Actuation LHD AWD/RHD AWD - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
COMPONENT LOCATION
Brake pedal
Hydraulic pipes
Integrated HCU (hydraulic control unit) and ABS (anti-lock brake system)
module
Brake ma
© 2011-2024 Copyright www.rrevoque.org