Range Rover Evoque: Brake systems (amber) - Warning lamps - Land Rover Range Rover Evoque Owner's ManualRange Rover Evoque: Brake systems (amber)

Brake systems (amber)
Brake systems (amber)

Illuminates briefly when the ignition is switched on. If the lamp illuminates after starting the engine or while driving, suspect worn brake pads or a fault with the Emergency Brake Assist (EBA) system. The vehicle can still be driven with care, but avoid heavy brake application.

Seek qualified assistance urgently.

    General warning/information message (amber)
    General warning/information message (amber) Illuminates when a non-critical warning message or an information message is available in the message centre. ...

    Dynamic stability control (amber)
    Dynamic stability control (amber) Illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC system is active. ...

    See also:

    Position light
    1. Turn the bulb socket counterclockwise and pull out the socket. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Install the bulb socket by turning it clockwise. ...

    Clearing the programmed information
    Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds) ...

    Infotainment system volume
    If no phone call is in progress, volume for the infotainment system can be adjusted in the normal way with the infotainment system's VOL control or from the steering wheel keypad. Infotainment ...