Jeep Liberty: Automatic Headlights — If Equipped
This system automatically turns the headlights on or off according to ambient light levels. To turn the system on, turn the end of the multifunction lever to the AUTO position (third detent). When the system is on, the Headlight Time Delay feature is also on. This means the headlights will stay on for up to 90 seconds after you turn the ignition switch to the LOCK position. To turn the Automatic System off, turn the end of the multifunction lever out of the AUTO position.
Headlight Switch
NOTE: The engine must be running before the headlights will turn on in the Automatic mode.
Headlights And Parking Lights
Turn the end of the multifunction lever to the first detent
for parking light operation. Turn the end of the lever to
the second detent for headlight operation.
Headlight Switch ...
Headlights With Wipers (Available With Automatic Headlights Only)
When this feature is active, the headlights will turn on
approximately 10 seconds after the wipers are turned on
if the multifunction lever is placed in the AUTO position.
In addition, the headli ...
See also:
Temporary spare tire (if equipped)
When a spare tire is mounted or a
wheel rim is replaced without the
original pressure sensor/transmitter
being transferred, the low tire pressure
warning light will illuminate
steadily a ...
Front seat heaters
Press the relevant button to operate the
required seat heater at high level. Three
indicators will illuminate.
Press a second time to heat the seat at a
medium level. Two indicators will illuminat ...
Fuel-filler cap
Fuel-filler cap
To remove the fuel-filler cap:
1. Turn the fuel-filler cap counterclockwise to
remove.
2. Put the fuel-filler cap on the cap holder A
while refueling.
To install the fuel-fi ...
