Honda CR-V: Auto Door Unlocking - Door Locks - Instruments and Controls - Honda CR-V Owner's ManualHonda CR-V: Auto Door Unlocking

The auto door unlocking feature has five possible settings:

The auto door unlocking is deactivated all the time.

The driver’s door unlocks when you move the shift lever to the Park (P) position with the brake pedal depressed.

This is the default setting.

All doors and tailgate unlock when you move the shift lever to the Park (P) position with the brake pedal depressed.

The driver’s door unlocks whenever you turn the ignition switch to the ACCESSORY (I) position.

All doors and tailgate unlock whenever you turn the ignition switch to the ACCESSORY (I) position.

To turn off the Auto Door Unlock modes:

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and open the driver’s door.

3. Push and hold the rear of the master door lock switch on the driver’s door. You will hear a click, and after about 5 seconds, you will hear another click.

4. Release the switch, and within 20 seconds, turn the ignition switch to the LOCK (0) position.

To program the Park Unlock mode:

Unlocks the driver’s door or all doors and tailgate when the shift lever is moved into the Park (P) position with the brake pedal depressed.

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and make sure to close the driver’s door.

3. Push and hold the rear of the master door lock switch on the driver’s door. You will hear a click.

Continue to hold down the switch:

Until you hear another click (after about 5 seconds) to activate driver’s door unlock feature.

Or, until you hear two more clicks (after about 10 seconds) to activate all doors and tailgate unlock feature.

4. Release the switch, and within 20 seconds, turn the ignition switch to the LOCK (0) position.

To program the Ignition Switch Unlock mode:

Unlocks the driver’s door or all doors and tailgate when the ignition switch is moved out of the ON (II) position.

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and make sure to close the driver’s door.

3. Push and hold the brake pedal, then move the shift lever out of the Park (P) position.

4. Push and hold the rear of the master door lock switch on the driver’s door. You will hear a click.

Continue to hold down the switch:

Until you hear another click after about 5 seconds) to activate driver’s door unlock feature.

Or, until you hear two more clicks (after about 10 seconds) to activate all doors and tailgate unlock feature.

5. Release the switch, and within 20 seconds, turn the ignition switch to the ACCESSORY (I) position.

Move the shift lever to the Park (P) position.

6. Turn the ignition switch to the LOCK (0) position.

    Auto Door Locking
    The auto door locking feature has three possible settings: The auto door locking is deactivated all the time. The doors and tailgate lock whenever you move the shift lever out of the Park (P ...

    Childproof Door Locks
    The childproof door locks are designed to prevent children seated in the rear from accidentally opening the rear doors. Each rear door has a lock lever near the edge. With the lever in t ...

    See also:

    Hill descent control (HDC) controls
    Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd o ...

    Restarting the tire pressure monitor
    WARNING It is the driver's responsibility to set the tire pressure to the recommended cold tire pressure. Underinflated tires affect the ability to steer or brake the vehicle. You might ...

    Cargo and dome lamp
    Rear cargo lamp equipped with an ON/OFF/DOOR control will light when: • the doors are closed and the control is in the ON position. • the control is in the DOOR position and any door is op ...