GMC Terrain: Airbag Readiness Light - Warning Lights, Gauges, and Indicators - Instruments and Controls - GMC Terrain Owner's ManualGMC Terrain: Airbag Readiness Light

This light shows if there is an electrical problem. The system check includes the airbag sensor(s), passenger sensing system, the pretensioners, the airbag modules, the wiring, and the crash sensing and diagnostic module. For more information on the airbag system, see Airbag System on page 3‑21

The airbag readiness light comes on and stays on for several seconds when the

The airbag readiness light comes on and stays on for several seconds when the vehicle is started. Then the light goes out.

WARNING

If the airbag readiness light stays on after the vehicle is started or comes on while driving, it means the airbag system might not be working properly. The airbags in the vehicle might not inflate in a crash, or they could even inflate without a crash. To help avoid injury, have the vehicle serviced right away.

    Passenger Safety Belt Reminder Light
    When the vehicle is started, this light flashes and a chime may come on to remind front passengers to fasten their safety belt. Then the light stays on solid until the belt is buckled. For more ...

    Passenger Airbag Status Indicator
    The vehicle has a passenger sensing system. See Passenger Sensing System on page 3‑28 for important safety information. The overhead console has a passenger airbag status indicator. Unite ...

    See also:

    To Select a Station
    You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select. TUNE - Use the TUNE knob to tune the radio to a desired fre ...

    Rear seats
    ■ Second seats Vehicles with third seat 1 Seat position adjustment levers 2 Seatback angle adjustment levers When a person sits in the rear center position, adjust both seat cushions t ...

    Putting ACC in standby mode
    Before ACC can be used to regulate speed and/or the distance to a vehicle ahead, it must first be put in standby mode. To do so: Press . The symbol appears in the display and parentheses ( ...