Honda CR-V: Adjusting the Sound - Playing the FM/AM Radio (EX and EX-L models without navigation system) - Features - Honda CR-V Owner's ManualHonda CR-V: Adjusting the Sound

Press the sound ( select an appropriate setting: bass, ) button to select an appropriate setting: bass, treble, fader, balance, subwoofer (if equipped), and SVC (speed-sensitive volume compensation). Turn the VOL/SELECT knob to adjust the setting.

BAS - Adjusts the bass.

TREBLE - Adjusts the treble.

FADER - Adjusts the front-to-back strength of the sound.

BALANCE - Adjusts the side-toside strength of the sound.

If equipped

SUBW - Adjusts the strength of sound from the subwoofer speaker.

Eachmode is shown in the display as it changes. Turn the VOL/SELECT knob to adjust the setting to your liking. When the level reaches the center, you will see ‘‘C’’ in the display.

SVC - Adjusts the volume level based on the vehicle speed.

The system will return to the audio display about 10 seconds after you stop adjusting a mode.

Speed-sensitive Volume Compensation (SVC)

The SVC mode controls the volume based on vehicle speed. The faster you go, the louder the audio volume becomes. As you slow down, the audio volume decreases.

The SVC has four modes; SVC OFF, SVC LOW, SVC MID, and SVC HIGH. Turn the VOL/SELECT knob to adjust the setting to your liking. If you feel the sound is too loud, choose low. If you feel the sound is too quiet, choose high.

This function is set to MID as the default setting when the vehicle leaves the factory.

    To Select a Station
    You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select. TUNE - Use the SEEK button to tune to a desired frequency. ...

    Audio System Lighting
    You can use the instrument panel brightness control knob to adjust the illumination of the audio system. The audio system illuminates when the parking lights are on, even if the system is tu ...

    See also:

    Traction AA, A, B, C
    The traction grades, from highest to lowest, are AA, A, B and C. Those grades represent the tire’s ability to stop on wet pavement as measured under controlled conditions on specified govern ...

    Windshield Wiper Blades
    Clean the rubber edges of the wiper blades and the windshield periodically with a sponge or soft cloth and a mild non-abrasive cleaner or use the washer solvent. This will remove accumulations o ...

    Headlight Time Delay — If Equipped
    This feature is particularly useful when exiting your vehicle in an unlit area. It provides the safety of headlight illumination for about 90 seconds after turning the ignition switch to the LOC ...