Honda CR-V: Adjusting the Sound

Press the SOUND (TUNE) knob repeatedly to display the BASS, TREBLE, FADER, BALANCE, and SVC (speed-sensitive volume compensation) settings.

BASS - Adjusts the bass.

TREBLE - Adjusts the treble.

FADER - Adjusts the front-to-back strength of the sound.

BALANCE - Adjusts the side-toside strength of the sound.

SVC - Adjusts the volume level based on the vehicle speed.

Eachmode is shown in the display as it changes. Turn the TUNE knob to adjust the setting to your liking.

When the level reaches the center, you will see ‘‘C’’ in the display.

Except SVC adjustment

The system will return to the audio display about 5 seconds after you stop adjusting a mode.

Speed-sensitive Volume Compensation (SVC)

The SVC mode controls the volume based on vehicle speed. The faster you go, the louder the audio volume becomes. As you slow down, the audio volume decreases.

The SVC has four modes: SVC OFF, SVC LOW, SVC MID, and SVC HIGH. Turn the TUNE knob to adjust the setting to your liking. If you feel the sound is too loud, choose low. If you feel the sound is too quiet, choose high.

This function is set to MID as the default setting when the vehicle leaves the factory.

READ NEXT:

 Audio System Lighting

You can use the instrument panel brightness control knob to adjust the illumination of the audio system. The audio system illuminates when the parking lights are on, even if the radio is turne

 Playing a Disc (LX model)

Playing a Disc (LX model)

 To Play a Disc

To load or play a disc, the ignition switch must be in the ACCESSORY (I) or ON (II) position. You operate the disc player with the same controls used for the radio. To select the disc player,

SEE MORE:

 Close and Lock the Doors.

After everyone has entered the vehicle, be sure the doors and the tailgate are closed and locked. Your vehicle has a door and tailgate open indicator on the instrument panel to indicate when a specific door or the tailgate is not tightly closed. Locking the doors reduces the chan

 VTC Actuator, Exhaust Camshaft Sprocket Replacement

Removal 1. Remove the cam chain. 2. Hold the camshaft with an open-end wrench, then loosen the variable valve timing control (VTC) actuator mounting bolt and exhaust camshaft sprocket mounting bolt. 3. If the VTC actuator will be reused, do these steps. Remove the intake camshaft, and seal the

© 2016-2024 Copyright www.hcrv.net